3D Printer Parts

• C

  CR Touch Z-Axis Home triggered
  • Chewieman  

  2
  0
  Votes
  2
  Posts
  10
  Views

  C

  @admin Please help. I have a useless printer until I get this resolved.
• A

  Bltouch correct homing, but problem while printing
  ender 5 pro bltouch v3.1 v427 • • Amazon62  

  2
  0
  Votes
  2
  Posts
  10
  Views

  

  Hi, @Amazon62 According to your description, it may be caused by high compensation value, please according to the video tutorial on leveling to adjust the compensation value. Leveling tutorial: https://youtu.be/9u4H6cm_CX4 You can remove the limit switch used before, and the wiring of BL-touch is shown below.
• H

  Creality 3d camera
  ender 3 pro 3d camera viewer • • haslo41  

  1
  0
  Votes
  1
  Posts
  9
  Views

  No one has replied

• L

  Help creality 3d viewer app
  • lucius pedrucci  

  4
  0
  Votes
  4
  Posts
  10
  Views

  H

  @aboulay hi which app did you use
• D

  CR-10 Smart camera add-on
  • davidgraham  

  1
  0
  Votes
  1
  Posts
  11
  Views

  No one has replied

• T

  xx-Touch
  • telephasic  

  1
  0
  Votes
  1
  Posts
  22
  Views

  No one has replied

• N

  Ender 3d pro 2 in one (3d print +laser Engaving)
  • nazideal  

  1
  0
  Votes
  1
  Posts
  15
  Views

  No one has replied

• F

  BL touch installed but bed leveling nowhere to be seen
  bl touch ender-3 pro • • Figeluren  

  2
  0
  Votes
  2
  Posts
  26
  Views

  F

  I figured out my mistake. When I was asked to load an hex file I just selected the one visible in the file selector which was 'Marlin.cpp.hex'. No instructions told my which file to load. As luck would have it I happened to notice file by mistake, 'Ender-3 Pro_1.1.6V_BLTouchV3.1PowerLossContinueEnglish.hex' in an earlier folder. And at my fourth attempt to flash the firmware I selected this one and YAAAAY it all works now. So please update and specify the hex file to be used. Best regards
• A

  HP-PLA-X3-3D Printer Filament
  • admin  

  1
  1
  Votes
  1
  Posts
  8
  Views

  No one has replied