Q1: Yes, we don't have affiliates for the UK store now until the end of September. Can you wait a month and you are welcome to join.
Q2: For the "Educational discount"-Up to 50% off for specific products, you can join our Facebook group: https://www.facebook.com/groups/crealitystore/ for more details.
Hello creality community,
I am new to this hobby... I recently got my s1 pro.. but there is way too much stringing in the initial prints....i have tried playing with maximum slicer settings inc retraction distance, speed, nozzle temp, layer height etc. But i couldnot eradicate the stringing part and also nozzle leakage... I have printed the printer test at 200 nozzle and 60 H/b and the cable holder at 195 nozzle and 60 H/b.
I have attached some picture. It would be of immense help if you all can guide me to the slicer settings thank you !!
I've replaced the heating element, thermostat, and a new hot end. I'm still getting this error. It was happening before the nozzle temp hit230 now it happening just before it hits 220. I'm running the current firmware version too on the CR10 Smart.
This error is all over the internet and I cant belive Creality is ignoring it.
Dear Creality Team,
I have some friends which with success use a longer Light Off Delay / Waiting time before curing to counteract the elephant foot on Resin printers. However, I cannot even test this method as I am limited by the Halot-Software.
The maximum Light Off delay both in the Halot Box and on the Printer is limited to 10s. However, much longer times are used to ungo the Resin being Squeezed" out of the curing area. More information on this method is fx shown in this Blogpost.
I would greatly appreciate if you could increase the Light Off Delay maximum allowed time (if not on the screen, than in Halot Box). Furthermore a seperate "Light Off Delay" only for the Bottom Layers would be very useful, but not necessarily required, as long as I can screw down the Light Off Delay on the printer manually.