Recently upgraded my Ender 3 Pro to the 4.2.7 Silent board. Printer was configured with the 4.2.2. board and the CR Touch. Flashed with the new board with the recommended firmware from the Creality.com site. (Ender-3Pro_HW4.2.7_SW188.8.131.52_CRTOUCH_standard)
Everything is running great. But two concerns:
The control panel displays "Ender-3 Ready" Shouldn't is say something like Ender-3 Pro ready?
When I turn the printer on it often times comes up in Chinese. I figured out how to change the language to English, and that isn't too bad. But I lose all my settings (Probe Z Offset, PID tune etc).
Is anyone else having this issue? And what is the resolution?
Hi, I have got a Creality CR10 V2. I was looking into the Sprite Extruder (https://www.creality3dofficial.com/products/sprite-extruder-direct), but I cannot figure out if the two are compatible.
Can I upgrade my printer with this printhead? Or do I need some sort of adapter?
I've the same issue with my Halot One as described in this older post:
Halot Sky OTA Firmware Update Broke My Printer
I've started a regular OTA firmware update as I've done already quite some times before without issues. This time the printer didn't start after the update. Only thing to see is the "Creality Ninja", and not even the animation, only a static image. I've also tried to connect the printer to Phoenix Suit but the printer did not even establish an USB connection at all. No menu, no remote access via USB, I don't know what else I can try to bring it back to live. The old topic didn't get any answers so my hopes are not that big. But at least I need to try before I dump the printer...
On the control panel, lower right hand corner, is an indicator that is apparently the "odometer" / service hours indicator. It works fine when printing from the SD card, it correctly adds up the total print time, but does not count the time from prints coming from Creality Cloud (from which most of my prints are initiated!
Anyone else experiencing this? If it's a common occurence, when is the fix coming?
Added a CR Touch and 4.4.7 motherboard along with a Touchscreen to my Ender-3 printer. When going to add a dual gear extruder had a problem with not enough filament being extruded. The reason is the diameter of the dual gears are smaller so each step less filament was extruded. I went to adjust the flow for each step but could not find anywhere to do that. Does anyone have a suggestion on what I can do so I can add a dual gear drive without designing my own.
The CR-Laser Bird of prey highlights what Creality alludes to as 'poly-focal point spot pressure laser innovation', which empowers a small spot size of just ...
Advantages and disadvantages: Simple to set up ⋅ Smooth and exact developments ⋅ Speed enhancements of multiple times Further queries you have to visit https://lumbuy.com/.
@Snoopy This is because our beloved, and absolutely not supported by Creality, CP-01 has a firmware bug that stops the extruder from working if the fan speed is not 0% or 100%.
To fix that, just edit your .gcode file with Notepad and search for all M106 instances (which is the fan speed code).
It should be either 0 or 255. Nothing else. Fix them all by hand (ie: If you see M106 65, put M106 255 instead, if you see M106 20, put M106 0) and save the file.
It will then print properly.