I saw this video where someone engraved the name of her baby on a baby bib.
I have the falcon pro2 22w and was wondering if someone would have starter speed/power to do this.
Note that the bib is made of “Food Grade Silicone - BPA free” - not sure if that really matters.
Any suggestion would be welcome!
I have engraved other silicone items, such as red silicone wristbands.
For those, I used 10,000 mm/min and 60% power on the 10W A1 (I generally use the 10W for engraving if nothing needs to be cut). I would assume that using half the power would be okay on the 22W, so around 30% 10,000mm/min. But it can vary a lot depending on the color. I would rather start slow and not move anything so if the effect wasn’t strong enough, go for another pass with more power.
Thanks @s3sebastian
I’ll give this a try this week-end and report bak - possibly with a picture if all went well.
Cheers!
