Hi!
I have a CR-10S with Marlin 2.1.2 and suddenly got some weird behaviour when it´s doing auto leveling.
I have a BLTouch V3 (I think) and I have tried to fix my configuration.h since when the printer try to do auto leveling (9 times) it just goes down a little on the Z and then it stops and then starts printing.
I have tried getting help from Chat GTP and Deepseek but without any luck.
So firstly I am intrested to get a working configuration.h and Adv.config.h and hopefully that will help. Unless anyone has any other Ideas.
Thanks for reading.