Ender 3 V3 Setup/Leveling

Hi, newbie to 3D printing here.

Sadly, I am currently stuck on the initial setup process (more specifically the “auto leveling” process) if I can get some kind of suggestion for troubleshooting:

Right now the extruder (currently with no filament in it), again during the leveling process, touches the middle of the print bed than goes all the way to the right and restarts itself (no error codes or nothing). Not sure if this an error in my setup of the printer, just the bed itself, or something else / all the above.

Like I said I am new to 3D printing and do not know where to start for troubleshooting and most of the videos (in which make it look easy) do have this issue I am having.

If anyone can please guide me in the right direction. Thanks.

doesnt it have an auto leveling bed? im thinking it is trying to initalize that so it learns where the bed is, but i am new to machines myself and having a set of my own problems but i thought i read something about the v3’s

Sorry yes, during auto leveling this issue occurs.

My printer behaved the same when the auto leveling sensor broke.

Please make sure the voltage selection switch is in the correct position for your region.