I recently had a massive print failure that resulted in a glob of filament stuck to my hot end. It took some force and other factors to clean it off but I finally have it working again however whenever I send a print to the printer (K1 Max) it slams against the back left and front right corners of the case and stutters a bit. It almost seems like something’s out of alignment, a belt is slipping, or something else happened to the drive mechanism when the glob occurred and the printer ran for some time without me shutting it down. Not sure what to check at this point I’m uploading a video in hopes that somebody can make some recommendations. I’ve restarted the printer, resliced the file, and done most of the basic troubleshooting.