K1C Problem with the first layer from the moment it was taken out of the box

[Bililu]

Hii, I’m having problems with the first layer too! I bought a K1C a week ago, and I’m having problems with it. If it helps you, here’s the link to the topic I started about it. If you want to add something there too, if it’s really the same problem, you’re welcome!

I’m afraid of opening my printer and making it worse, so I’m trying other solutions

First Layer problem K1C

I made this change with the Z offset, I started at zero (green/blue), then changed it until the mark decreased (before 0.05), left it at 0.05 until the mark ended (green) and decreased it to zero again (pink). I took another first layer test file and increased the temperature a little too. I also looked at the bed leveling by IP, and it seems out of calibration. I didn’t want to disassemble it, because it’s still under warranty [image] [IMG_9821] [image]