Massive blob

[Radical_Data]

Hello,

Have you tried this idea ?

Click the link and scroll to the solution by Howard.

I replaced the hot end and this happened

I think the connection between the hot-end heater and the connection within the heat sink is not tight. I am not familiar with this hot-end but most are either the teflon tube is not tight against the nozzle but more likely your heat break is not tightened against your nozzle. I had this issue when I switched to a Slice engineering heat break which tightens against the nozzle. In the long run I purchased a torque tool from them and tightened it up and all was well after that. But before that I …