Need Help - Laser Falcon A1 do not work anymore

Hello Creality Community,

I have big problems. I use a used Falcon A1 10W since a couple of month. Everything working fine but yesterday I made a camera calibration because I do not see the working are perfect.

First try was better so I start a second try an if there was the task with the spots. The laser do not markt the dots. The laser went without any marking. I try old projects same. I always use the little black focus tool

What I have done:

Cleaning air flow of laser and box

Cleaning glass of laser but it was very clean in my opinion

Restart of complete system including Software

The Green light on the laser module for Power working but the laser status LED do not. I try with full Power and low speed and nothing happens.

My last idea is a firmware update to get sure that nothing happen with the software in the background.

Could anyone help me, I need the laser for the christmas business :wink:

Thank you in advance for your strong support.

Regards

Erik

Since you previously removed the laser head to clean it, perhaps you didn’t fully engage the power plug.

Re-check to ensure the power plug (on the side of the laser head) is connected.

Hello,

thank you for your answer. I doublecheck the plug and the metal bar to hold it. The Green light is on, so I think there must be power.

The only thing what I did’t check is the mainboard.