Printing problems with PLA

I have some trouble with the look of my printed parts. There’s some holes on the two faces of my parts. I need help.

I tried all theese things ;

-increase the wall line count
-reduce the speed for the outer wall, the initial layer and the top/bottom speed





Looking at the ragged edge and the tearing I would say your Z offset is a little too close to the bed, adjust it back a little.

1 Like

Hello @Phillernouch …! :wave:

Welcome to the Creality Forum…! Creality

In addition to what @Bonfireman suggested maybe try a flow calibration test. Possibly increasing would help… Using Creality Print 5.xxx is here :arrow_heading_down:

Flow-Calibration