I noticed again a change in form and placement of the purge line in CR Print. A couple of versions before there was this L on the left/front side. Then it changed to the Bambu version Fat line/slim line in the front. Way shorter, way easier to peel off.
Now with 7.2.1 it is again this L. Any reasons for this? Changeable?
こんにちは。
がっかりしました。
前回の方短いのが良かったです。
次回のバージョンアップで戻してくれる事に1票入れます。
wondering the same thing
こんにちは。
ファームウエア・CrealityPrint最新版にUPしたら戻ってました。
I can confirm that, but I was already on 7.2.1. Today, however, I got a notification in CP about some parameter updates. I checked, and it was only some “new filament types”. I thought it couldn’t hurt, and boom — after the update, the thin/thick line was back again. Hehe, I hope it stays this time. I already rammed the L under my fingernail once again this morning. That really hurts…
こんにちは。
そもそも、このラインは必要なんでしょうか？
このラインがプリントされても1層目のサポートやプリントが上手く行くとは限らない。
Sure, that is never guaranteed. Treat it as like a first touchdown or final preparation, kind of legacy. If it would be absent, you would be wondering too 