I have an upgraded E3 V2 with a sonic pad and it is printing well. I have never gotten a speed increase off using the sonic pad, at least not enough to talk about. I thought I would play around and see if I could speed things up a bit but am not getting anywhere, probably due to not knowing what I am doing.
I take a benchy and slice it without changing any settings, 1:20 (h:m roughly). Looks good, just slow. I change settings in the slicer and the estimated time does not change. For example, I go to the speed tab and multiply the speed settings x1000 (just for testing) and the print time after slicing still says about 1:20. This makes me think there is a hard limit somewhere that I am not seeing, or I am not changing the settings actually being used. Any suggestions on where to look?
Thanks!