Support material removal

Flagship K Series Creality Flagship K2 Plus & CFS
1

Hello,

I just upgraded to Creality Print V7.2.0.5226 and after printing, I find removing support material is nearly impossible. I had no issues prior to this update. That’s the only thing I can think of that changed from when it was all good. I am using PLA and PLA-CF. I’ve tried changing nozzle temp to 200C, Z gap changes, basically what I’ve read in this forum about getting supports to release easier. I don’t understand why alll of sudden I cannot remove support material. Any help would be appreciated.

2

Same here WTF

3

I use tree supports, z axis at .23 and 3 top layers. my supports fall off or stick to the bed when I pull the print off. They come off super clean

4

I will try that when I get home from work and let you know. Thanks for the input.

1 Like
5

Are you using 0.2 layer thickness?

6

That worked much better. Trees came off part clean and were easy to remove from the plate. Thanks for the tip!!

7

i use .2 to .4 thickness depends on the print,

8

glad i could help

9

I use slim tree supports, 2 interface layers with 0.05mm more than my layer height, so for 0.2mm layers 0.25 top z. And have great luck with support removal