- Creality - Space Pi Plus -
- I still can’t print with TPU 95A on my Bambulab A1.
this is frustrating
Here in Barcelona it’s super humid
I bought a filament dryer from Creality
As recommended by chatgpt I dried the filament for 8 hours at 55 degrees.
and the print came out as if it was aerated, there was no solid body (image 01)
Then, following the recommendation on the bambulab website I let it dry at 70 degrees for 8 hours. That’s what I did and the print was even worse!!! (image 02)
The two photos are from the beginning of this cube (Image 03) but I stopped it early because I realised that the filament wasn’t printing properly.