CR-6 SE Freezing mid-print.



  • @admin, Is anyone going to acknowledge this failure and provide a fix??? I would like a printer that is not wasting 25% of my time and filament. This printing failure is happening too often to be anything but a hardware failure, and I have done what I can to reasonably eliminate other errors on my end.



  • Oh Creality should DEFINITELY provide fixed boards (AND replacement glass beds for beds ruined by following the CR-6 manual, AND replacement power switches, and and and, so many unaddressed issues), but I've not had an e-mail reply from them for two weeks now, so I'm just going to chalk it up as a loss and pay for spares and reparis myself and remember these things when I'm shopping for a printer next time. Definitely never buying from Creality directly again, since resellers ALL seem to have WAY better customer service.



  • @shinmai I just mad te same purchase but I think @admin should consider providing us fixed main boards.

    Because the default FW, even the latest, doesn't seem to use the EEPROM of the board, if the problem happens while booting the bed leveling is lost. For me this cause the the nozzle to scrap the surface, damaging both and making the printing experience not stable and the printer not worth the hype or the price.



  • This is what I've been worried about with my printer, since I don't dare to attach it to USB until Creality has addressed the USB issue.
    Even though @admin has said on these forums that repeated insertions don't cause the SD slot on the control board to wear out and become unresponsive, just based on common sense and other user's posted experiences, I don't believe this to be true. (Also, admin has a habit of saying things that later turn out not to be true, unfortunately, either on purpose or accidentally.)

    I've been using a microSD adapter in the printer and just removing the microSD card from that instead of repeatedly removing and inserting a full-sized SD card to reduce mechanical stress, but will be replacing that set-up with an SD-card extension cable once the part arrives.



  • When this happened to me I noticed the that the name of the printed file disappeared from the menu.

    I notice some mechanical issue with the SD reader that doesn't allow the printer to read the card or loose the access while reading it.

    In my case I have contacted the support, waiting for a reply.



  • @shinmai Thank you!

    @admin Are you able to help?



  • The Creality account has been MIA for a bit now, you're probably better of tagging the account called "admin", although they, too, seem to be very selective as to which users to reply to and assist 😕



  • @Creality help?



  • So, @Creality, Are you going to offer any advice or support?



  • No, a Sandisk 4gb and a Samsung 8gb. Both have been long-formatted before use with this printer to FAT32 @ 4096 bytes



  • Are you using the SD card that came with the printer? I had this happen to me a few times, swapping the unknown brand Creality provided SD for a Sandisk one fixed it and it hasn't happened since.


Log in to reply
 

Copyright © 2020 Shenzhen Creality 3D Technology Co., Ltd All Rights Reserved.