Ender-3 32-bit_ 2.0.1_Latest Firmware_0813(1)
Enclosed, please find the newly updated firmware for Ender-3 32-bit:
@all, Dear All, this is only for Ender-3 32 bit, for other series, I am doing the update work, please be a little patience, I will have you know if I upgrade anything. Thanks for all your supports.
@beejack because its NOT for the Ender 3 V2
@timd1971 this is just v1.0.1 (marlin 2.0.1) but with the old Ender 3 pro screen enabled - same as v.1.0.1 for E3 V2 but with a different screen - nothing new here firmware wise and still way behind Marlin 2.0.6
Ender 3 Pro's are now being shipped with V.4.2.2 (32 bit) motherboards but the same (old) pro screen - so this is just a firmware with that compatibility. its is NOT suitable for E3 V2 or any better than the standard E3 V2 firmware.
Make sure you use the CORRECT download:
06 Aug, 2020
Ender-3 V2_Latest Firmware_V1.0.1.zip
The one they just added is for the 32bit boards they are recently replacing the old boards with for the Ender 3 and should probably be the Ender 3 Pro also. But you need to probably open up the case and double check if u have new black 32 bit v4.2.2 board. If you notice, the new update is under Ender 3 NOT Ender 3 V2 anyways. Have to be real careful installing firmware meant for different device.
Creality isn't quite consistent with all of this...but seems they are trying.
The new 32 bit gets updated via MicroSD card.
Doesn't work on the V2
Once updated nothing on screen just keeps beeping.
Had to go back to the previous version.
On the page it says 1.0.1. Is it 1.0.1 or 2.0.1?
Also, it would be great if there was a readme file explains what is updated.
Thanks. In the Readme i found out that it's also for the Ender 3 V2. Can you please write if there is a difference between this firmware and the one in the Ender 3 V2 section?
Apparently it's the same version 1.0.1 and also the same Marlin 2.0.1.