Ender 3 V2 - leveling problem
-
Hi,
I just completed insallation of my new V2
I am trying to adjust bed level.
I turned all leveling knobs so that the bed is in the lowest position. (mainly the back side leveling knobs seem to be at the lowest position.9
It is just leveled with the Z axis stop switch.
Paper is hardly moving below the nozzle.is this normal ?
-
Hi, there are a couple ways of leveling the printer, it might be a bit difficult at first but will get easier over time. You can watch some tutorial videos on youtube how to do it like https://www.youtube.com/watch?v=YHP2DfRl-GQ and make some test prints to see if every corner is aligned correctly: https://www.youtube.com/watch?v=VOBkerYJJ8s