AB Touch Firmware Install Issues



  • Hi all from the UK. So i purchased a BL Touch which is now installed to the printer all ok. I have updated the firmware (eventually) using the Ender-3Marlin1.1.6BLTouch version on Creality website.

    My mainboard is V1.1.4. The display is now different to before with different menu structure.

    The problem is when I Autohome the Z Axis keeps trying to go down. I have tried to adjust the Z stop in the Motion setting but there is no Save changes in any of the menus. On teaching Tech he mentions about adding BLT somewhere to tell the printer the AB Touch is installed but I do not know where to add this? Any guidance would be greatly appreciated so I can start printing again.


Log in to reply
 

Copyright © 2020 Shenzhen Creality 3D Technology Co., Ltd All Rights Reserved.