Tighten Heater in Block?



  • I had a major mess of melted filament that oozed on all sides of the heater. Looked like my Ender when it had a leaky nozzle. Not sure what it was but I managed to get things cleaned up without damaging the fine wires to the thermistor.

    I noticed that the heating element was moving in its slot so I looked for ways to tighten it down. I found what appears to be a set screw on the down side and tightened it but it didn't solve the problem. Anybody know where the set screw to tighten the heater is?



  • @johnelle Its down there. Creality has a video showing complete tear down. Look for the pinned post at the top of this sub.


Log in to reply
 

Copyright © 2020 Shenzhen Creality 3D Technology Co., Ltd All Rights Reserved.