Ender 6 stuck on boot after bltouch
-
Please would someone help me with this? My screen has been stuck on boot for days now. I've tried display firmware and board. It won't load or flash anything....
-
Same issue. Ender 6. BLTouch v3.1. Board is V 4.3.1. Please send instructions.
-
Is the Bltouch official supported on the ender 6?
And why is the firmware not in the download section?I would like to build a bltouch on my ender 6 but I don't want to brick the mainboard whit a faulty firmware.
regards,
Jan
-
Dear @kouyang50
- Motherboard, only the screen line and power input, unplug all other wires and then boot test (if the boot test is normal, one by one plug to exclude parts failure)
- Reinsert the screen cable and the motherboard socket of the screen cable.
- re-flash the firmware (you need to provide a picture of the motherboard, according to the version of the motherboard with the corresponding firmware and send you a tutorial)