Bed is higher than extruder

  • Hello community,
    I'm relatively new at 3d printing(I have Ender 3 Pro) and I ocured problem with instaling new spings to my bed.
    ![0_1606848899102_IMG_20201201_121308.jpg](Nahrávám 100%)

    • Spings are at the max stretch and can't go any lower.
      So my question is: Can I get somehow switch axis Z higher so extruder didn't colide with bad ?
      I'd be thankfull for any tips


  • Thank you for advice,
    I come across video where dude have same springs
    and he just move up few centimetres the switch so yeah.
    But thank you your effort. I need to keep learn about it so
    I became more profesional.

    Have a great day.

  • As in your other thread, the image didn't upload.

    I'm not super familiar with the Ender, but if you can move the Z limit switch higher, you could get the hotend to not be as low. Obviosuly you'll lose build volume with this solution so hopefully someone with more experience with the Ender series can offer something more convenient, but if you're in a rush to get printing, that's one option you could use.

Log in to reply