Hotend Silicon Boot
HI, I have an issue finding spares for the Creality CR6-se, can you please inform me where can I get a replacement silicon boot for the hot-end?
I purchased the common variety found on Amazon, "Fits all Creality Printers, only to find they do not fit.
When looking at the open edge of the silicon boot, the Creality CR6-SE silicon boot has the nozzle hole centred, on the other boot, the nozzle opening is offset to one side (left).
I would appreciate your advice.
Thanks for taking the time to eventually reply to me. However the link you have posted is for a complete hot-end kit. I Only need to change the silicon hot-end cover. I am not paying for a hole new unit just to replace the rubber cover.
you can purchase the CR-6 SE silicon block at the link below: