Does the Creality Slicer software work on a Mac?
-
Does the Creality Slicer software what comes on the SD Card work on a MAC?
-
Dear @Qwajman
You can download CR-6SE slicing software from this link, which contains configuration information
https://www.creality.com/download
-
Where can I find the printer profile for the Mac version of Cura? There is no printer profile listed for the CR-6SE. Or what profile should I use and do any of the settings need to change?
-
@Gekopmac,
there also PrusaSlicer, Ultimaker Cura (a lot of options)
what I miss the profile of the CR-6 SE.Henk
-
Dear @Jimmielt3
The slicing software provided with the printer's SD card does not support MAC. Please download the cura slicing software from the CURA official website. Don't worry, it can be used.
-
That’s also my problem. I’m a starter with 3D printer and now. Loze in the forrest.
-
It strictly states in the instructional booklet that not to use any other slicer software other than that came on the SD card.
-
No, mac can only use Cura
