Esteps vs Transmission Ratio



  • Hello All!

    I am relatively new into the 3D printing world and absorbing as much knowledge as I can. So throughout my research, I noticed that one of the initial steps is to calibrate E-Steps. I followed the procedure and came to the conclusion that I was underextruding. I then noticed that I didn't have an E-Steps option menu, but I DID have a Transmission Ratio (default 93%). I have adjusted this and have had solid prints, but I haven't been able to find detailed knowledge on the matter. I have been undergoing trial and error, but I would love to know if there is a way to truly dial it in by knowing how E-Steps and Transmission Ratio correlate with each other.

    Thank you for any and all help!

    https://all3dp.com/2/ender-3-calibration-how-to-calibrate-your-ender-3/ [ESTEPS RESOURCE]


Log in to reply
 

Copyright © 2020 Shenzhen Creality 3D Technology Co., Ltd All Rights Reserved.