Z-Offset Problem?
-
Hi there,
I started a print today and left. When I checked it for the first time after 15 minutes, the CR6 printed in the air.
I stopped printing and did home leveling, but the printer stopped too far from the heatbed. The Z-sensor is activated and the printer stops.
I haven't changed anything since the last successful print, possibly I turned the Z-axes to remove filament from the nozzle. But even if I turn the Z-axes again, nothing changes.
I have downgraded the firmware from the MB and upgraded it again, without success.
Can somebody help me?
Firmware: V2.0.1.3
-
Same problem since V2.0.1.3
Not possible to solve with FW downgrade. Printer is useless now.
-
me too bro, same problem
my firmware its too V2.0.1.3
-
Hi,
is your printer able to find home, e.g., when you press this "auto home" button in the leveling dialogue?
This sounds like a bug in the firmware, I have encountered, too.
(see https://forum.creality.com/topic/1561/creality-cr-6-se-it-just-keeps-getting-worse-until-there-is-no-home)
And this could be related to the "homing failed" problem (see https://forum.creality.com/topic/1338/cr-6-se-homing-issue).Bad news is, there is no fix, yet.