I started a print today and left. When I checked it for the first time after 15 minutes, the CR6 printed in the air.
I stopped printing and did home leveling, but the printer stopped too far from the heatbed. The Z-sensor is activated and the printer stops.
I haven't changed anything since the last successful print, possibly I turned the Z-axes to remove filament from the nozzle. But even if I turn the Z-axes again, nothing changes.
I have downgraded the firmware from the MB and upgraded it again, without success.
Can somebody help me?
Same problem since V188.8.131.52
Not possible to solve with FW downgrade. Printer is useless now.
me too bro, same problem
my firmware its too V184.108.40.206
is your printer able to find home, e.g., when you press this "auto home" button in the leveling dialogue?
This sounds like a bug in the firmware, I have encountered, too.
And this could be related to the "homing failed" problem (see https://forum.creality.com/topic/1338/cr-6-se-homing-issue).
Bad news is, there is no fix, yet.