CR20 bed warp issue - was fine but now totally off

  • 2021-01-13 01_05_45-Window.png

    This is my CR20 after a bed level mesh vizualization, it was fine for ages, but now it wont print properly, this is it visualised with a glass top, which I put on today but its been like this for a while, it even looks like this when the glass is removed.

    The bed has warped, plainly put, after about 2 months this has happened. When I print now the bottom right corner is not sticking and the corner by the cable is now digging into the bed.

    How easy is the job to fit a set of springs and wheels? Looks easy enough though I guess you have to cut the magnetic top to get to it - which I guess with a glass top I could just replace the entire bed then I suppose with a new one?

  • Dear @Scrubbins
    There is a specific platform for after-sales service, you are welcomed to leave your questions here, our people will feedback to you quickly


Log in to reply