CR-10S Pro V2 - circular shapes have flat spots



  • Was printing a ball socket segment (hollow) for a camera holder. Noticed that when it was printing it would complete one circular rotation, then reverse direction for the next layer. Where this occurred there were flat areas on the outer & inner wall on opposing sides of the part. Using Cura as a slicer and have it slicing for my model printer. Layers looked good and otherwise no issues with the print.
    Is there a setting in Cura to make it not reverse direction like that?


Log in to reply
 

Copyright © 2020 Shenzhen Creality 3D Technology Co., Ltd All Rights Reserved.