BL touch installation



  • Hello I wanted to install a BL touch bought at Creality shop the flashing of the firmware went well at least I thought since the index on the screen indicated BL touch Ready
    But in fact nothing is going as soon as I start the machine it tries to find the plate then goes up in Z until it hits the bar if I do not stop it urgently which has already solved this problem
    I have seen that many CR users have this problem why Creality does not provide well coded Firmware?
    There are a lot of things made for the Ender but very little for the CR
    thank you


Log in to reply
 

Copyright © 2020 Shenzhen Creality 3D Technology Co., Ltd All Rights Reserved.