CR-100 does not print first few slices



  • I was able to load, slice and print a Hero Forge figurine from an stl file.

    Now, I can't get a successful print of it or any other file.

    It's as if the first couple of slices aren't printing.

    I have it set to print a brim around the pieces. I get just the thinnest ghost of a brim as if it's only printing the topmost layer of it. It's not a proper brim with some substance to it.

    I've tried calibrating the printer by adjusting the printhead to slightly score a piece of paper between it and the build plate and then pressing the home button.

    I'm flummoxed. Any ideas?


Log in to reply
 

Copyright © 2020 Shenzhen Creality 3D Technology Co., Ltd All Rights Reserved.