Ender 3 Pro Firmware Original, and How Make Mods

  • I have a new ender 3 pro, the screen says Marlin 1.0.1, and has a date 2020-04-20.
    It has a creality board V4.2.2

    1. Is there a way I can get a copy of the original firmware so I can reload it if I mess something up?
    2. It looks like HAS_RESUME_CONTINUE is configured, as M0, and M1 do not stop. I would like to add that in. Where can I get a copy of the configuration files used to make the firmware I have - ie the correct options for the type of thermistor, correct stepper drivers etc.
    3. Any good tutorial on how to build the marlin software on windows? My first attempt resulted in:
      make: *** No rule to make target applet/wiring.o', needed by applet/Marlin.elf'. Stop.

    ![0_1613927243117_ReduceLCD.jpg](Uploading 100%)

  • I know this is an OLD thread but I have the exact same question for the exact same printer/hardware rev/software rev.

    Does anyone have any info on how to get the existing source for what comes on these machines by default.

    I know the Ender pro is long in the tooth but it seems like Creality doesn't care about it at all but is still selling tons of them.

Log in to reply