CR-10S V2 bed leveling EVERY turn off and on printer



  • I set up initial length of z-axis by the 100mm from the sticker. Then after manual leveling bed set up perfectly 0.20 every corner. When I turn off my printer and turn on everithing is messed up. Bed level is offset when i go to settings and check it out again. Nothing is changed only turn off and on.
    Does it must to be set every on/off printer? I didn't print yet anything. Please help what I should to do return the printer?



  • Dwar @fr3sh

    In order to better serve our users and solve their after-sales problems in a timely manner,
    our technical team has created an official after-sales platform:

    For after-sales issues with Creality products, please move to the official after-sales channel, where we have the professional after-sales staff to deal with your after-sales issues in real-time.

    Below is the official after-sales channel portal, if you have any after-sales issues, please contact us on this platform. Thank you for your support.

    https://www.creality.com/service-request


Log in to reply
 

Copyright © 2020 Shenzhen Creality 3D Technology Co., Ltd All Rights Reserved.