Error 202 Homing Failed



  • My CR-6SE failed during a print with a blocked nozzle. So I turned the printer off, cleaned the nozzle, and tried to start over again. The printer turned out spaghetti, so I tried to run autolevel. The autolevel stopped by showing an error message: "Error 202 Homing Failed".

    I powered off, waited, and turned on again. When the printer homes, it stops a few centimeters above the plate a few times, then gives the same error message.

    What should I do?


Log in to reply
 

Copyright © 2020 Shenzhen Creality 3D Technology Co., Ltd All Rights Reserved.