• I have had a ld-001 since January and although I have a few good prints mostly I just have failure.

    Getting things to stick to the bed and not just the cat is a nightmare. I have levelled it a hundred times but it just doesn’t seem to want to stick. The shop is telling me to fine sand paper the bed but I am not sure about this. Is there a test print and setting I can try to work out what is wrong.

    I am going through a large amount of resin and getting nothing for it.

    Any help would be great

  • @Rowny01

    You may try this method: Re-leveling and heating the hotbed to 60° before printing, applying solid glue to the carbon glass / slicing the model with a base / applying paper to the carbon glass to increase the adhesion of the model

Log in to reply