Ender 5 Plus Part Cooling Fan



  • Old guy new to all of this.

    I have had the printer for 3 weeks. I'm impressed by the way it is put together. There are a few small build quality problems that were overcome and started the learning curve that comes with 3D printing. Bed leveling an ongoing problem; several prints stopped after the first layer but ended up with a complete rabbit. And if I do say so an impressive rabbit.

    My current problem is that I have noticed the Parts Cooling Fan has stopped running. The fan works with a separate power supply but no power from the control board in print mode. Firmware or board failure? Would appreciate feedback.

    I will read all of the leveling comments in the forum. It seems to not come back to the same place twice when leveling.

    PS Meanwell power supply, Firmware Ver 1.70.2bl


Log in to reply
 

Copyright © 2020 Shenzhen Creality 3D Technology Co., Ltd All Rights Reserved.