CR10 V3 bed leveling



  • I checked the table and it is flat.

    I level out the 4 corners getting a slight rub on the paper in each; however the center of the table is low - no rubbing of the paper anywhere across the X axis. The paper measures 0.10mm. If I fold it (to double the thickness) over I get a heavier rub in the center telling me the center of the table is about 0.10mm lower than the corners. I confirmed with feeler gages where a 0.1mm feeler has a slight rub in the corners and a 0.18mm feeler has a slight rub in the center.

    Might it be that the Y axis guideway has a bow in it of about 0.08mm?



  • Dear @Mel-M

    In order to better serve our users and solve their after-sales problems in a timely manner,
    our technical team has created an official after-sales platform:

    For after-sales issues with Creality products, please move to the official after-sales channel, where we have the professional after-sales staff to deal with your after-sales issues in real-time.

    Below is the official after-sales channel portal, if you have any after-sales issues, please contact us on this platform. Thank you for your support.

    https://www.creality.com/service-request


Log in to reply
 

Copyright © 2020 Shenzhen Creality 3D Technology Co., Ltd All Rights Reserved.