ender 5 pro, board 4.2.7, pin27 adapter, bltouch1.3.1, creality firmware from site.



  • I was able to upgrade my board and using a pin27 adapter get the bltouch connected. used the firmware from here for the 4.2.7 board bltouch 1.3.1 with adapter. I set the z offset to -2.25 but when i print a model i sliced in cura it prints in the upper right corner but not centered on the bed like in cura. I'm losing my mind trying to figure out what's wrong. it's a standard ender 5 pro except for the bltouch and the 4.2.7 board.

    any help would be appreciated.


Log in to reply
 

Copyright © 2020 Shenzhen Creality 3D Technology Co., Ltd All Rights Reserved.