Glass bed marks

  • I've noticed a lot of posts asking how to clean the bed because there are marks from the print. I've only had mine for a handful of prints, but I noticed my nozzle was making the marks on the first outline of the print. I offset the z-axis by 0.05mm and it's working much better. The auto-leveling had the nozzle pressing hard against the glass and wasn't yielding material until the third or fourth pass. Hope this helps anyone!

  • @Mrs_Brown Thank you for the info. I had the exact opposite problem: the nozzle was too far from the bed and I always had to put -0,10 Z adjustment when printing. Is it also possible to move up or down the z-end switch to get rid of the problem definitively.

  • Dear @Mrs_Brown

    Thanks for sharing the information.

Log in to reply

Copyright © 2020 Shenzhen Creality 3D Technology Co., Ltd All Rights Reserved.