Autohome Problems with ender 3 pro



  • Hello,
    I made an upgrade on my ender 3 pro since yesterday.
    Namely a BL touch.
    I have actually proceeded exactly according to instructions. The board is an 8 bit board 1.1.4
    Have installed this firmware ( Pro1.1.6BLTouchV3.1PowerLossContinueEnglish.hex)

    When I do an autohome the z axis goes up instead of down.

    Have also attached a video with.

    https://youtu.be/6e4bfYRpczA

    Thank you
    Marcell


Log in to reply
 

Copyright © 2020 Shenzhen Creality 3D Technology Co., Ltd All Rights Reserved.