CR-200B Teething issues

  • Hi here is a new owner of a CR200B (one week owner), but I have a few questions after playing around for a week:

    I hooked up octopi to control the printer... which runs brilliant, but have some issues/questions...

    The temperuture data is reported double, which is kind of a pain.... The fix as reported on the octopi forum only fixes it once every lines... Can you please fix the firmware?

    Secondly M140 S0 doesn't disable the bed heater; it sets the set temperature to 0, causing the printer to remain in an always trying to cool state as it will never reach 0 at room temperature and never finish the print... Is there a custom code required to finish the print job? Now the code hangs on M140 S0 and won't accept a M85 / M81 to shutdown the machine after reaching a sufficiently low temperature....

    Lastly, is it possible to disable the 5VDC+ over the serial? Is there a jumper setting of a software setting that allows for that? Taping the pin in the USB just ain't right

    We are running the as shipped firmware? Many thanks!

Log in to reply

Copyright © 2020 Shenzhen Creality 3D Technology Co., Ltd All Rights Reserved.