CR-200B Teething issues
Hi here is a new owner of a CR200B (one week owner), but I have a few questions after playing around for a week:
I hooked up octopi to control the printer... which runs brilliant, but have some issues/questions...
The temperuture data is reported double, which is kind of a pain.... The fix as reported on the octopi forum only fixes it once every lines... Can you please fix the firmware?
Secondly M140 S0 doesn't disable the bed heater; it sets the set temperature to 0, causing the printer to remain in an always trying to cool state as it will never reach 0 at room temperature and never finish the print... Is there a custom code required to finish the print job? Now the code hangs on M140 S0 and won't accept a M85 / M81 to shutdown the machine after reaching a sufficiently low temperature....
Lastly, is it possible to disable the 5VDC+ over the serial? Is there a jumper setting of a software setting that allows for that? Taping the pin in the USB just ain't right
We are running the as shipped firmware? Many thanks!
1, M140 S0 means the temperature of the hot bed is set to 0 degrees Celsius, which makes the machine can not complete this command, so it has been hanging there, because the machine does not have a cooling function, can not make the temperature of the hot bed to 0 degrees Celsius, please set the temperature to room temperature or 26 degrees Celsius or 30 degrees Celsius
2, can not disable 5VDC through the serial port