Auto home issues



  • Just bought this printer, set up, but when I auto home, it goes to the front left corner and makes a god awful noise. I cannot see a limit switch anywhere to tell the printer where the end is. Can someone assist with this? I have not tried to print from a slicer, just hit the auto home button.



  • There is zip tie holding the extruder for shipping. Did you cut that? I had the same problem when I started as well.



  • @chokulat Homing on the Ender 3 is in order X, Y then Z. Which axis is crashing?
    You said front left which implies X homes successfully before moving on to Y. So I'm guessing it is Y that crashes?


Log in to reply
 

Copyright © 2020 Shenzhen Creality 3D Technology Co., Ltd All Rights Reserved.