Thinking about buying
I hope to be buying the CR 6 SE soon. I have read a lot of people talking about defective mainboards and power switches that can cause a fire. Have these problems been solved on the new productions or should I also be looking into purchasing solutions to those problems as well, such as the BTT SKR board and a higher quality switch?
@Dweeb1313 My two cents and I am currently quite happy with my CR6, learned a few tricks, as usually happens with 3D printers, I would still buy it.
There have been a few problems but the most recent FW solved it and the community CR6 FW gives also ways to plan upgrades.