Stringing on CR-5 PRO
-
Hi there!
I cannot seem to stop stringing when printing with PLA no matter what I do.
I have tried retractions from 1-8.25mm
Retract speeds up to 80mm/s
Temps from 195-220
Z hopStarting to think this may be a hardware issue, anyone have any ideas or have had these issues?
-
Nozzle temperature to 200
retractions to 8-10mm
if there is the phenomenon of drooping material or a long time not to replace the nozzle, replace the nozzle with a new one.
You can also replace other volumes of filaments, if the filaments are damp, there will also be a lot of drawing can not be adjusted by the parameters
-
I'm having the same issue. I've tried everything I can think of, and I can't get it to go away.