Stringing on CR-5 PRO



  • Hi there!

    I cannot seem to stop stringing when printing with PLA no matter what I do.

    I have tried retractions from 1-8.25mm
    Retract speeds up to 80mm/s
    Temps from 195-220
    Z hop

    Starting to think this may be a hardware issue, anyone have any ideas or have had these issues?



  • @Thane3D

    Nozzle temperature to 200
    retractions to 8-10mm
    if there is the phenomenon of drooping material or a long time not to replace the nozzle, replace the nozzle with a new one.
    You can also replace other volumes of filaments, if the filaments are damp, there will also be a lot of drawing can not be adjusted by the parameters



  • I'm having the same issue. I've tried everything I can think of, and I can't get it to go away.


Log in to reply
 

Copyright © 2020 Shenzhen Creality 3D Technology Co., Ltd All Rights Reserved.