CR-20Pro Stop error



  • Hello, I have the following problem with my CR-20Pro, whatever I try, home or start print, it starts up then it fires the probe of the stock Bltouch, it retracts and fires again, then it change status to stop.

    I checked with a new Bltouch probe from my other machine, I checked the cabling and replaced it from another working CR-20PRO, but it stays the same.

    Needless to say that swapping the Bltouch and the cable does not help.

    https://1drv.ms/v/s!AvyIpZMoaXr5gXfhH91zFJ7fNkWb

    Here you can see what I mean, I run a stock machine only with Marlin 2.0 bugfix firmware.

    Help please!

    Kind regards,
    Etienne


Log in to reply
 

Copyright © 2020 Shenzhen Creality 3D Technology Co., Ltd All Rights Reserved.