5 pro will no longer auto home or print



  • Selecting 'auto home' results in the print head moving to the rear-right home position for a moment but then it moves to approximately the center and the display says 'STOPPED'. It also will not print at all.
    It is a model Ender 5 pro and has the 4.2.2 board inside. It is only a week old. It worked perfectly for about 6 small prints, now has lost its mind. Please help, How do I fix it?



  • Dear @magarity

    Check whether it is a problem with the slice file, replace the file that was successfully printed before to see if there is still an abnormality, try to refresh the firmware if it is not a problem with the slice file


Log in to reply
 

Copyright © 2020 Shenzhen Creality 3D Technology Co., Ltd All Rights Reserved.