Change 3D print starting point.

  • I've had an Ender 3 for a couple days now and have successfully printed out several object from Thingiverse. However, for one specific print, it seems to start the print in the corner and everytime the corner will start to "lip" up. I was thinking if the print start down one of the long lines on the print, I could have a better chance of success.

    • How do I change the starting point of the print?

    It needs to start in the middle of one of the long sides rather than the corner where it "lips" up.
    I am using Cura for Slicer and Fusion 360 for modeling.

Log in to reply