Cura Settings required for CR-10 V3



  • Re: CURA Printer Profile: CR-10 V3

    I am using Cura and looking for appropriate profile settings for my CR-10 V3. The only option in Cura is for the: CR-10

    The V3 uses a direct drive Titan extruder, therefore the default settings for the V2 or any other CR-10 may not be appropriate.

    For example, I understand that the CR-10 default retraction setting of 5mm is far too much for the V3.

    So if anyone has suitable V3 settings, please advise.


Log in to reply
 

Copyright © 2020 Shenzhen Creality 3D Technology Co., Ltd All Rights Reserved.